|
05-05-2019, 09:53 PM
|
#1
|
Junior Member
Join Date: May 2019
Posts: 24
|
New to site..just bought cruiser 276 2012 toyhauler
Looking for any help with getting to know this trailer better. Dealership wasnt much help.
First problem is motorized stabilizers 3 of 4 not working. My bad on not making them run them at the dealership. Assuming after checking to see I have power I have to remove the motors as I dont see a manual option?
Thanks for any help.
__________________
|
|
|
05-06-2019, 06:41 AM
|
#2
|
Senior Member
Join Date: Jan 2012
Location: South Dakota
Posts: 3,105
|
I can't offer much help since I ordered without the electric stabilizers due to their failure rate.
However, I went thru all the papers/owners manual that came with my camper and zero info on the stabilizers.
IIRC, I believe I read somewhere with the electric stabilizers, there is a rubber plug that can be removed to access the screw to operate the jacks manually with the same tool used to lower/raise the spare tire under the garage and/or operate the electric tongue jack if need be.
Check this link: http://www.funfinderclub.com/forums/...acks-1507.html
And this video toward the end:
__________________
__________________
2012 Fun Finder XT 276 Toy Hauler & Harley Davidson Ultra Classic with Condor wheel chock
2014 Dodge Ram 2500 AT 4X4 Crew Cab 6.4 L Hemi, 373 gears, tow package, Rambox option, Revolver X2 tonneau cover, Equal-I-zer anti-sway hitch.
|
|
|
05-16-2019, 12:31 AM
|
#3
|
Junior Member
Join Date: May 2019
Posts: 24
|
Thanks for the help.
Antenna connection? I see a cable in on the side of the trailer. How does that work with the antenna. I see you said you replaced your antenna.
I may have some questions for you later as I see you have the same camper.
|
|
|
05-16-2019, 08:23 AM
|
#4
|
Senior Member
Join Date: Jan 2012
Location: South Dakota
Posts: 3,105
|
The cable connection on the outside the trailer is for just that ... cable TV.
Behind your TV in the camper, there is a outlet to plug in the TV power cord and a wall plate where the TV/cable screws onto. Both the cable from the outside and the roof top antenna feed signal to your TV thru the same connection inside the trailer. Right beside where the television antenna cable screws to the wall plate connector, there is a little button Push the button in and a little green light is illuminated indication power to your antenna.
Hope this helps.
__________________
2012 Fun Finder XT 276 Toy Hauler & Harley Davidson Ultra Classic with Condor wheel chock
2014 Dodge Ram 2500 AT 4X4 Crew Cab 6.4 L Hemi, 373 gears, tow package, Rambox option, Revolver X2 tonneau cover, Equal-I-zer anti-sway hitch.
|
|
|
05-17-2019, 05:52 PM
|
#5
|
Junior Member
Join Date: May 2019
Posts: 24
|
Quote:
Originally Posted by Eagle
The cable connection on the outside the trailer is for just that ... cable TV.
Behind your TV in the camper, there is a outlet to plug in the TV power cord and a wall plate where the TV/cable screws onto. Both the cable from the outside and the roof top antenna feed signal to your TV thru the same connection inside the trailer. Right beside where the television antenna cable screws to the wall plate connector, there is a little button Push the button in and a little green light is illuminated indication power to your antenna.
Hope this helps.
|
Ok so I finally got the slide out and was able to take a look. I have two coax connections behind the tv.
The botton one has the antenna/cable switch with coax on it.
The top one is just a coax connection.
So is the top on the cable. I would have guessed the bottom one was for both antenna and cable as there is a switch on it tk go from one to the other.
Does yours have two coax connections on two separate plates behind the TV?
|
|
|
05-17-2019, 08:42 PM
|
#6
|
Senior Member
Join Date: Jan 2012
Location: South Dakota
Posts: 3,105
|
Quote:
Originally Posted by Str8ball
Ok so I finally got the slide out and was able to take a look. I have two coax connections behind the tv.
The botton one has the antenna/cable switch with coax on it.
The top one is just a coax connection.
So is the top on the cable. I would have guessed the bottom one was for both antenna and cable as there is a switch on it tk go from one to the other.
Does yours have two coax connections on two separate plates behind the TV?
|
Oh .. I forgot I had my son change out the roof top antenna and removed the factory cheap Jensen that wouldn't pickup anything and installed a King Jack HD antenna that rotates for best channel selections & has a signal strength indicator. What I described earlier is what I have now.
There was only 1 wall plate. I will check and see if I have the parts removed for the new antenna set up.
__________________
2012 Fun Finder XT 276 Toy Hauler & Harley Davidson Ultra Classic with Condor wheel chock
2014 Dodge Ram 2500 AT 4X4 Crew Cab 6.4 L Hemi, 373 gears, tow package, Rambox option, Revolver X2 tonneau cover, Equal-I-zer anti-sway hitch.
|
|
|
05-22-2019, 07:34 AM
|
#7
|
Member
Join Date: May 2019
Location: Fenton, MI
Posts: 45
|
New to the site also. Just purchased a 2013 XT276 toy hauler. I had a bad right rear jack motor and the dealer replaced both rear jacks.
I had everything working on shore power and TV power but nothing on battery. From what I'm reading on other threads, the disconnect has to be pulled out to be on. It has no label telling me that and if it's on the knob, well that went missing.
|
|
|
05-22-2019, 08:11 AM
|
#8
|
Senior Member
Join Date: Jan 2012
Location: South Dakota
Posts: 3,105
|
The battery disconnect switch must be in the 'on' position when towing or you will not have any power to the trailer brakes should the camper come disconnected from the tow vehicle...FYI
__________________
2012 Fun Finder XT 276 Toy Hauler & Harley Davidson Ultra Classic with Condor wheel chock
2014 Dodge Ram 2500 AT 4X4 Crew Cab 6.4 L Hemi, 373 gears, tow package, Rambox option, Revolver X2 tonneau cover, Equal-I-zer anti-sway hitch.
|
|
|
05-22-2019, 09:15 AM
|
#9
|
Senior Member
Join Date: Feb 2012
Location: Southern California
Posts: 2,142
|
Did you buy the trailer from the dealer? If so, they should be able to show you where the battery disconnect switch is located. It is usually on or near the same control panel that controls the lights and the pump.
|
|
|
05-22-2019, 09:27 AM
|
#10
|
Senior Member
Join Date: Jan 2012
Location: South Dakota
Posts: 3,105
|
On the XT 276, the batter disconnect switch is a silver knob located on the 'switch panel' just inside the door on the left side below the sink......where the rocker switches for the awning, water pump, lights, slideout, etc. are located.
When the knob is pulled out, it's in the "on" position. Pushed in is the "off" position.
FYI .. due to the location, it's easy to bump it and push it in or 'off".
__________________
2012 Fun Finder XT 276 Toy Hauler & Harley Davidson Ultra Classic with Condor wheel chock
2014 Dodge Ram 2500 AT 4X4 Crew Cab 6.4 L Hemi, 373 gears, tow package, Rambox option, Revolver X2 tonneau cover, Equal-I-zer anti-sway hitch.
|
|
|
05-22-2019, 09:35 AM
|
#11
|
Senior Member
Join Date: Feb 2012
Location: Southern California
Posts: 2,142
|
Shelley, to solve the "accidental bump" problem, I put an eye hook (like a cup hook) over the shaft of the battery disconnect switch, so that it can't be pushed in by accident. Simple and low-tech, but it works.
__________________
|
|
|
|
Thread Tools |
Search this Thread |
|
|
Display Modes |
Linear Mode
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Threads |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|