After using the trailer for the first time, I liked the placement of the TV on the flip down mount over the sink, but it was a bit inconvenient using the sink. Had to turn the TV all the way to the left, or flip it up. One of my original placement ideas was on the door above the sink, so I decided to try it. I used a piece of plywood for this experiment before I go drilling holes in the door. I used the TV mount as a template for drilling the mounting holes, and the original door for hinge placement, door support placement and door catch placement. I cut a hole in the panel behind the TV for the wires to go through. The only issue I have is that the top edge of the TV hits the ceiling before the door supports hold. If the TV was mounted an inch lower, they would support it. If this idea works out, I'll order a new door that has the same edge detail but has a flat surface and use it. That way I can keep the original door just in case. Here are a couple of before and after pics.
Before
Before
After
After