TV arm for garage

[crashmonkey85]

Id like to add a TV arm to the garage of my 2014 XT 276. It came with the mount attached to the wall which is the same as one used in the dinette area and forward sleeping area. I have a 19 inch TV and I want to get the arm that is compatible with these mounts. What is the brand I need to look for?

 

[roy-FUN]

You better just take the one out of living area first and see if the back room mount will even support a TV. Mine fell off in my arms first time I skid the TV into the wall mount. Its a poor mount with only two 1/2" wood screws holding it into the 1/4" fiber wall board. Terrible quality and design.

 

[omigosh]

I'm looking for one too. I scoured the internet and cant seem to find anything that looks like a similar style. There are also no markings on the one in the dinette area to indicate who makes it. I was thinking of calling Cruiser to see if they could sell me one or tell me where they get them.

I have hung the TV back there and it held fine. However, the cable connection doesn't work which the dealer can't seem to figure out.

 

[Bill & Cindy]

TV Mount

On my 1012 XT-276 the TV mount is an Arrowmounts AM-P16B.

 

[Dakota 1120]

Re: TV Mount

On my 1012 XT-276 the TV mount is an Arrowmounts AM-P16B.

Not the same as in my 2012 XT-276. The only marking on the mount fastened to the wall with 2 screws is a stick on tag that says "MADE IN CHINA"

It's more like this:

http://www.ebay.com/itm/Tilt-Swivel-TV-Wall-Mount-Bracket-For-19-20-22-24-inch-/261287005325

EXEPT the mount to the wall takes a slip i tapered slide with a place for a slip in pin on the lower end that will hold the swivel bracket that is mounted to the back of the 19" TV

 

[roy-FUN]

Mine came with the box that the mount came in. I have it at home I will post up what brand and type it is. This is what came in our 2012 XT276. As stated above it may be different for the following years.